Concept Guide

828| show aaa authentication-server radius Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
NAS IP N/A
Enable IPv6 Disabled
NAS IPv6 N/A
Source Interface N/A
Use MD5 Disabled
Use IP address for calling station ID Disabled
Mode Enabled
Lowercase MAC addresses Disabled
MAC address delimiter none
Service-type of FRAMED-USER Disabled
Radsec Enabled
Radsec Trusted CA Name can-new
Radsec Server Cert Name N/A
Radsec Client Cert client-new
called-station-id macaddr colon disable
The output of this command includes the following information:
Parameter Description
host
IP address of the RADIUS server
Key
Shared secret between the controller and the
authentication server.
CPPM credentials
Setting this parameter allows the controller to use
configurable username and password instead of a
support password.
Auth port
Authentication port on the server.
Acct Port
Accounting port on the server.
Radsec Port
Displays the Radsec port for RADIUSdata transport.
Retransmits
Maximum number of retries sent to the server by the
controller before the server is marked as down.
Timeout
Maximum time, in seconds, that the controller waits
before timing out the request and resending it.
NAS ID
Network Access Server (NAS) identifier to use in
RADIUS packets.
NAS IP
NAS IP address to send in RADIUS packets. If you do
not configure a server-specific NAS IP, the global NAS
IP is used.
Enable IPv6
Shows if the RADIUS server is enabled in IPv6 mode.
NAS IPv6
IPv6 address for the global NAS IP which the controller
uses to communicate with all the RADIUS servers.