Concept Guide

adp
adp discovery {disable|enable} igmp-join {disable|enable} igmp-vlan <vlan>
Description
This command configures the Aruba Discovery Protocol (ADP).
Syntax
Parameter Description Range Default
discovery
Enables or disables ADP on the controller. enabled/
disabled
enabled
igmp-join
Enables or disables sending of Internet
Group Management Protocol (IGMP) join
requests from the controllers.
enabled/
disabled
enabled
igmp-vlan
VLAN to which IGMP reports are sent. — 0 (default
route VLAN
used)
Usage Guidelines
Dell APs send out periodic multicast and broadcast queries to locate the master controller. If the APs are in the
same broadcast domain as the master controller and ADP is enabled on the controller, the controller
automatically responds to the APs’ queries with its IP address. If the APs are not in the same broadcast domain
as the master controller, you need to enable multicast on the network. You also need to make sure that all
routers are configured to listen for IGMP join requests from the controller and can route the multicast packets.
Use the show adp config command to verify that ADP and IGMP join options are enabled on the controller.
Example
The following example enables ADP and the sending of IGMP join requests on the controller:
adp discovery enable igmp-join enable
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide adp | 133