Concept Guide

show snmp user-table
show snmp user-table [user <username> auth-prot [sha | md5] <value> priv-prot [aes | des]
<value>]
Description
Displays the list of SNMP user profile for a specified username.
Syntax
Parameter Description
auth-prot
Authentication protocol for the user, either HMAC-MD5-98 Digest Authentication Protocol
(MD5) or HMAC-SHA-98 Digest Authentication Protocol (SHA), and the password for use
with the
designated protocol.
priv-prot
Privacy protocol for the user, either Advanced Encryption Standard (AES) or CBC-DES
Symmetric Encryption Protocol (DES), and the password for use with the designated
protocol.
Example
The output of this command shows the list of SNMP traps sent to host.
(host) # show snmp user-table
SNMP USER TABLE
---------------
USER AUTHPROTOCOL PRIVACYPROTOCOL FLAGS
---- ------------ --------------- -----
Sam SHA AES
fire SHA AES
Command History
This command was available in ArubaOS 3.0
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show snmp user-table | 1896