Concept Guide

Table Of Contents
show interface fastethernet
show interface fastethernet <slot>/<module>/<port>
Description
Displays information about a specified fast Ethernet port.
Syntax
Parameter Description
access-group
Displays access groups configured on this interface.
counters
Displays L2 interface counters for the specified interface.
switchport
Displays L2 interface information.
untrusted-vlan
Displays port member vlan untrusted status.
xsec
Displays xsec configuration.
Examples
The example below shows the output of show interface fastethernet 0/0/1.
FE 0/0/1 is up, line protocol is up
Hardware is FastEthernet, address is 00:0B:86:51:14:D1 (bia 00:0B:86:51:14:D1)
Description: fe1/0
Encapsulation ARPA, loopback not set
Configured: Duplex (AUTO ), speed (AUTO )
Negotiated: Duplex (Full), speed (100 Mbps)
MTU 1500 bytes, BW is 100 Mbit
Last clearing of "show interface" counters 15 day 21 hr 34 min 53 sec
link status last changed 15 day 21 hr 32 min 16 sec
1122463 packets input, 196293018 bytes
Received 661896 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
661881 multicast, 460567 unicast
191428 packets output, 97063150 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
This port is TRUSTED
POE Status of the port is OFF
The output of this command includes the following parameters:
Parameter Description
FE 1/0 is...
Displays the status of the specified port.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show interface fastethernet | 1559