Concept Guide

show uplink
crypto-local
show uplink [config|{connection <link_id>}|signal|{stats <link_id}]
Description
Displays uplink manager configuration details.
Syntax
Parameter Description
config
Enter the keyword config to display the uplink manager, the default
wired priority and default cellular priority
connection
Enter the keyword connection followed by the uplink ID number to
display the connection details.
signal
Enter the keyword signal to display the cellular uplink signal strength.
stats
Enter the keyword stats followed by the uplink ID number to display the
statistical information on the designated uplink.
Example
The output of this command displays the controller uplink status . For a branch controller, the health status of
these uplink connections is also displayed in the Status section of the Dashboard>WAN page of the branch
controller WebUI.
(host) #show uplink
Uplink Manager: Disabled
Uplink Health-check: Enabled
Uplink Health-check IP/FQDN: 192.0.2.14
Uplink Management Table
-----------------------
Id Uplink Type Properties Priority State Status Reachability
-- ----------- ---------- -------- ----- ------ ------------
1 Wired vlan 4094 200 Connected Active Reachable
2 Cellular Novatel_U727 100 Standby Ready Reachable
Related Commands
Command Description
ip probe default
This command configures WAN health-check ping-probes for measuring
WAN availability and latency on branch controller uplinks.
uplink
Manage and configure the uplink network connection.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show uplink | 1962