Concept Guide

show ap load-balancing
show ap load balancing
Description
Show the load-balancing information for each AP with load balancing enabled.
Examples
The output of the command in the example below shows details for a single AP enabled with the load-
balancing feature.
(host) #show ap load-balancing
Load Balance Enabled Access Point Table
---------------------------------------
bss ess name Port ip phy chan cur-cl util(kbps)
--- --- ---- --- -- --- ---- ------ --
00:0b:86:cc:8e:4e Wireless_1 mp22 0/0/4 10.3.148.12 a-HT 413 3 14
The output of this command includes the following information:
Column Description
BSS
The Basic Service Set (BSS) Identifier for the AP. This is usually the APs MAC
address.
ESS
The Extended Service Set (ESS) Identifier is the user-defined name of an
802.11 wireless network.
port
The controller slot and port used by the AP, in the format
<slot>/<module>/<port>.
ip
IP address of the AP
phy
One of the following 802.11 types
l a
l a-HT (high-throughput)
l g
l g-HT (high-throughput)
chan
Channel number for the AP 802.11a/802.11n physical layer. The available
channels depend on the AP’s regulatory domain (country).
cur-cl
Current number of clients on the AP.
util (kbps)
Current bandwidth utilization, in kbps.
Command History
Introduced in ArubaOS 3.0.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap load-balancing | 1182