Concept Guide

Table Of Contents
show ap mesh-ht-ssid-profile
show ap mesh-ht-ssid-profile [<profile>]
Description
Show configuration settings for a mesh high-throughput Service Set Identifier (SSID) profile.
Syntax
Parameter Description
<profile>
Name of a mesh high-throughput SSID profile.
Usage Guidelines
High-throughput APs support additional settings not available in legacy APs. A mesh high-throughput SSID
profile can enable or disable high-throughput (802.11n) features and 40 Mhz channel usage, and define values
for aggregated MAC protocol data units (MDPUs) and Modulation and Coding Scheme (MCS) ranges.
The command show ap mesh-ht-ssid-profile displays a list of all mesh high-throughput SSID profiles
configured on the controller, including the number of references to each profile and each profile’s status.
Include the optional <profile> parameter to show detailed settings for an individual mesh high-throughput
SSID profile.
Examples
The example below shows the configuration settings for the mesh high-throughput radio profile default.
(host) #show ap mesh-ht-ssid-profile default
Mesh High-throughput SSID profile "default"
-------------------------------------------
Parameter Value
--------- -----
40 MHz channel usage Enabled
BA AMSDU Enable Enabled
Temporal Diversity Enable Disabled
High throughput enable (SSID) Enabled
Legacy stations Allowed
Low-density Parity Check Enabled
Maximum number of spatial streams usable for STBC reception 1
Maximum number of spatial streams usable for STBC transmission 1
MPDU Aggregation Enabled
Max received A-MPDU size 65535 bytes
Max transmitted A-MPDU size 65535 bytes
Min MPDU start spacing 8 usec
Short guard interval in 20 MHz mode Enabled
Short guard interval in 40 MHz mode Enabled
Supported MCS set 0-23
The output of this command includes the following information:
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap mesh-ht-ssid-profile | 1198