Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Getting Started
- 3 Basic Operation
- 4 Sonde Menu
- 5 PC6000 Software
- 6 Principles of Operation
- 7 Maintenance
- 8 Troubleshooting
- 9 Communication
- Appendix A Health and Safety
- Appendix B Require Notice
- Appendix C Warranty and Service Information
- Appendix D Accessories and Reagents
- Appendix E Application Note
- Appendix F Solubility and Pressure/Altitude Tables
- Appendix G Sensor and Sonde Storage Recommendations
- Appendix H Turbidity Measurements with the 6000UPG
- Appendix I System Errors and Warnings
2-16
ECOWATCH FOR WINDOWS
If you have purchased Ecowatch for Windows, install the program from the Program Manager
menu of your Windows system. Use this software with an IBM-compatible PC with a 386 (or
better) processor. The computer should also have at least 4MB of RAM and Windows Version 3.1
or later. First close any Windows applications which are currently running. After inserting the
Ecowatch floppy disk in your disk drive, access the File command from the top menu bar of the
Program Manager window. Click on Run and type “a:\setup.exe” at the prompt. Press
Enter or
click on “OK” and the display will indicate that Ecowatch is proceeding with a setup routine.
After the setup is complete, you will be prompted to confirm that all applications have been closed
and choose the hard drive location where Ecowatch will be installed. After answering these
questions, the installation of Ecowatch will take place automatically. Simply follow the instructions
on the screen after installation is complete.
2.5 PC6000 SOFTWARE SETUP
To start the software, make your current drive C:\PC6000 (or another directory where you have
installed PC6000). Type
PC6000 and press Enter. The PC6000 software will load. The PC6000
menu bar will appear at the top of the computer screen:
Sonde File Setup Real-Time Exit PC6000