Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Getting Started
- 3 Basic Operation
- 4 Sonde Menu
- 5 PC6000 Software
- 6 Principles of Operation
- 7 Maintenance
- 8 Troubleshooting
- 9 Communication
- Appendix A Health and Safety
- Appendix B Require Notice
- Appendix C Warranty and Service Information
- Appendix D Accessories and Reagents
- Appendix E Application Note
- Appendix F Solubility and Pressure/Altitude Tables
- Appendix G Sensor and Sonde Storage Recommendations
- Appendix H Turbidity Measurements with the 6000UPG
- Appendix I System Errors and Warnings
5-20
5.5 THE SETUP MENU
Choosing the Setup option from the menu bar allows you to configure the PC program to your
specifications. Highlight Setup, from the menu bar and press Enter.
+------------------------------------------------------------------------------+
¦ Sonde File Setup Real-Time Exit YSI PC6000 ¦
¦------------------------------------------------------------------------------¦
¦ ¦
¦ ¦
The setup menu will be displayed:
+------------------------------------------------------------------------------+
¦ Sonde File Setup Real-Time Exit YSI PC6000 ¦
¦------------------------------------------------------------------------------¦
¦ ¦
¦ ¦
¦ ¦
¦ -----DISPLAY-FORMATS----- -----------COMPUTER-CONNECTIONS----------- ¦
¦ Date format: mdy Comm port: 1 ¦
¦ Date separator: / Baud rate: 9600 ¦
¦ Time separator: : Printer port: 1 ¦
¦ Radix mark: . Printer type: HP LaserJet laser ¦
¦ ¦
¦ ¦
¦ -------MORE-SETUP-------- -------------COMPUTER-DISPLAY------------- ¦
¦ Data capture setup... Menu colors: Bering Sea (color) ¦
¦ Advanced Setup... Plot colors: Ohio River (color) ¦
¦ Graphics mode: Automatic selection hi-res ¦
¦ ¦
¦ ¦
¦ ¦
¦ ¦
¦ ¦
¦------------------------------------------------------------------------------¦
¦ Press Enter to access advanced setup items ¦
+------------------------------------------------------------------------------+
Other than the Comm port and Printer port options, the default values are adequate to perform
virtually every function of the 6000
UPG.
Select these options if it is necessary to change the default communications setup. These options
must be properly set before attempting to communicate with the software inside the sonde. See
Section 4.5. If you have difficulty communicating with the sonde, change the comm port and try
again. PC6000 allows only Comm port 1 or 2.
The baud rate can be changed by highlighting it and pressing Enter. Select from a list of possible
baud rates which will be displayed. The baud rate you select here must match the baud rate set in
the sonde (which defaults to 9600). See Section 4.3.
Comm port: 1
Baud rate: 9600