Manual

4-20
4.6 REPORT SETUP
Select 6. Report setup from the sonde Main menu to configure all reports constructed by the
sonde. You will be able to design the report with regard to parameters and units of measure which
are viewed on the computer screen during operation. The following display will appear on
selection of Report Setup.
For this example, the parameters date, time, temperature in °C, specific conductance in mS/cm,
salinity, DO in percent air saturation, pH, and battery voltage will appear on the screen in all
sampling and viewing applications. The “c” marker for temperature and specific conductance
indicate that these parameters have conditions applied to them (See section 4.1.2).
To change the screen display using this menu, simply press the number of the parameter with its
desired units to cause it to appear in the screen display associated with real-time Discrete and
Conditional Sampling and with the View and Quick View options of the File Menu. When a
particular choice is active, an asterisk (or a “c”) will appear in the parentheses associated with the
========================================
Main
----------------------------------------
1. Run 5. System setup
2. Calibrate 6. Report setup
3. File 7. Sensor setup
4. Status 8. Diagnostics
Select option (0 for previous menu):
========================================
Report-setup
----------------------------------------
1-(*) Date G-(*) Sal ppt
2-(*) Time H-(*) DO %
3-(c) Temp C I-( ) DO mg/L
4-( ) Temp F J-( ) Depth ft
5-( ) Temp K K-( ) Depth m
6-(c) SpCond mS/cm L-(*) pH
7-( ) SpCond uS/cm M-( ) pH mV
8-( ) Cond mS/cm N-( ) ORP mV
9-( ) Cond uS/cm O-( ) NH4+ mg-N/L
A-( ) Resist MOhm*cm P-( ) NH3 mg-N/L
B-( ) Resist KOhm*cm Q-( ) NO3- mg-N/L
C-( ) Resist Ohm*cm R-( ) Turb NTU
D-( ) TDS g/L S-( ) TDG mm-Hg
E-( ) TDS kg/L T-(*) Batt V
F-( ) TDS mg/L
Select option (0 for previous menu):