User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
36
b. Next, specify the Authentication Timeout settings. This is the session time period
(minutes) which users are allowed to be logged in to your wireless network. Once the
time expires, users will automatically logged and will need to log back in through the
captive portal page again in order to reconnect to your wireless network. It is
recommended to set a value to ensure authentication sessions are closed after a certain
time period. Setting the value to 0 minutes allows users to be authenticated and
connected to your captive portal WiFi network without any time restrictions.
c. Click Apply at the bottom of the page to save the initial captive portal authentication
settings.
Add an advertisement or redirect URL/address/website
After your users authenticate and connect to your captive portal WiFi network, you may
want to redirect your users to a specific URL, address, or website for advertisement
purposes.
Check the Advertisement URL Enable setting and enter the URL/address/website in the
field Enter Advertisement URL. Click Apply at the bottom of the page to save the
settings.
Note: The prefix http:// or https:// must be included when entering
URLs/addresses/websites (ex. https://www.trendnet.com)