User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
7
C. Initial Wireless Setup
1. Using your computer and web browser, access the wireless controller management
page using the newly assigned IP address settings (configured in Section A) and login.
Note: If the IP address settings were not changed in Section A, the IP address settings for
the controller are 192.168.10.200 / 255.255.255.0.
2. Click Monitor and click Devices.
3. The access points will be discovered automatically and appear in the Device List.
Note: If the access points do not appear, make sure the access points are powered by
checking the physical LEDs and physical cable connections and refresh the page.
4. After the access points are discovered and appear in the Device List, under the Action
column, click on each access point to add them to the wireless controller.
5. Once the access points have been added to the wireless controller, the Status will
change from NEW to RUN.
6. Click Configuration and click Wireless Groups/Profiles.