User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
28
5. In the Online Firmware Update prompt, click OK to start the online firmware upgrade
process. Please wait for the firmware upgrade process to complete.
Note: By default, the Internal Memory settings is selected to temporarily download the
firmware files to the controller’s internal memory for the firmware upgrade process. If a
USB storage device is plugged into the controller’s USB port, the external storage device
will appear as an available storage location to download the firmware files for the
firmware upgrade process.
Please note the following:
Do not interrupt the firmware upgrade process. Do not turn off the device or
push the reset button during the firmware upgrade. Rebooting or resetting
during the firmware upgrade process may permanently damage your access
point.
6. During the online upgrade, messages will be displayed next to the current firmware
version to indicate the firmware upgrade status. After the firmware upgrade has
completed successfully, the new firmware version will be displayed.
Downloading – Indicates that the new firmware files are currently being
downloaded to the selected storage location.
Updating - Indicates that the device is currently being updated to the new
firmware.
Completed – Indicates that the firmware upgrade has completed
successfully.
Failed – Indicates that the firmware upgrade process failed.
Note: You can try the online firmware upgrade again or manually download
the firmware file from the TRENDnet website and upgrade the firmware
manually.