User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
34
5. To assign additional APs to the new group, repeat steps 3 & 4 and after you have
assigned all the desired APs to the new group, you can create wireless profiles under the
new wireless group.
6. To create new wireless profiles under the new wireless group, click on Configuration
and click Wireless Groups/Profiles.
7. In the Select Wireless Group drop-down list, select the new wireless group. (e.g. R&D)
8. To create a new wireless profile for the new group (e.g. R&D), in the list below, click
Create. For details on wireless profile settings, you can refer to the section “Creating a
wireless profile” on page 24.
Below is an example of 2 wireless groups with multiple wireless profiles from each
group.
2 x APs assigned to wireless group “Default group”
2 x APs assigned to wireless group “R&D”
3 x wireless profiles created under “Default group”
3 x wireless profiles created under “R&D”
2 x APs will broadcast and allow connections for the 3 wireless profiles created
under “Default group”
2 x APs will broadcast and allow connections for the 3 wireless profiles created
under “R&D”