User manual

146
Advanced Mode:
The advanced mode consists of the event and action sections. You can define the
action to take for each event triggered on the IP cameras or the video servers
connected to the NVR.
To configure the advanced event management by the “Advanced Mode”, select an
event type on the left channel list and configure the actions to take on the right.
Note:
 Click “Apply” to apply the settings or “Exit” to exit the settings page. If the
“Advanced Mode” is selected on the “Alarm Settings” page, the advanced
settings will be applied after the NVR restarts even if you have selected to exit
the settings page. The settings will be cancelled if you select to use “Traditional
Mode” after exiting the “Advanced Mode”.
 To avoid blocking by the firewall, the IP cameras or the video servers configured
for the alarm recording must be located on the same subnet as the NVR.
 To switch from the advanced mode to the traditional mode, select “Traditional
Mode” and click “Apply”.