User manual
Table Of Contents
- Table of Contents
- Safety Warning
- Chapter 1. Introduction
- 1.1 Overview
- 1.2 Hardware Illustration
- 1.2.1 VS-8040U-RP/VS-8032U-RP/VS-8024U-RP
- 1.2.2 VS-8040/VS-8032/VS-8024
- 1.2.3 VS-6020 Pro/VS-6016 Pro/VS-6012 Pro
- 1.2.4 VS-5020/VS-5012
- 1.2.5 VS-4016U-RP Pro/VS-4012U-RP Pro/VS-4008U-RP Pro
- 1.2.6 VS-4016 Pro/VS-4012 Pro/VS-4008 Pro
- 1.2.7 VS-4016U-RP
- 1.2.8 VS-2012 Pro/VS-2008 Pro
- 1.2.9 VS-2012/VS-2008
- 1.2.10 VS-201P/V
- 1.2.11 NVR-104P/V
- 1.2.12 VS-101P/V
- Chapter 2. Install VioStor
- Chapter 3. Use VioStor by Local Display
- Chapter 4. Use VioStor by Web-based Interface
- Chapter 5. Playback the Video Files
- Chapter 6. System Administration
- Chapter 7. System Maintenance
- Chapter 8. LCD Panel
- Chapter 9. Troubleshooting
- Appendix A Dynamic Domain Name Registration
- Appendix B Configuration Examples
- Technical Support
- GNU GENERAL PUBLIC LICENSE
125
6.4 Device Configuration
You can configure the SATA disk, RAID management tool, USB disk, and the UPS
settings in this section.
6.4.1 SATA Disk
This page s
hows the model, size and current status of the hard disk drive(s)
installed on VioStor. You can format the HDD and check the status, and scan the
bad blocks. When the HDD are formatted, VioStor will create the following default
share folders:
record_nvr: The folder to where the regular recording files are saved.
record_nvr_alarm: The folder to where the alarm recording files are saved.
Click the icons on the “SATA Disk” page to format the hard disk drive(s).
Disk Configuration Applied NVR Models
Single disk volume All models
RAID 1, JBOD (just a bunch of disks) 2-bay models or above
RAID 5, RAID 6, RAID 5+hot spare 4-bay models or above
RAID 6+hot spare 5-bay models or above