User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
45
Operating Temperature
0 – 40° C (32 – 104° F)
Operating Humidity
Max. 90% non-condensing
Dimensions
215 x 130 x 44.45mm (8.27 x 6.3 x 1.73 in.)
Rack mountable 1U height
Weight
762g (1.7 lbs.)
Certifications
CE
FCC
Disclaimers
*For wireless controller compatibility, access points must have the corresponding
firmware versions listed below.
TEW-755AP (Firmware Version: 1.04 or above)
TEW-821DAP (Firmware Version: 1.06 or above)
TEW-825DAP (Firmware Version: 1.02 or above)
**Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and coverage will vary depending on
interference, network traffic, building materials and other conditions.
***Due to regulatory requirements, the wireless channels specified cannot be statically
assigned, but will be available within the available wireless channels when set to auto.