User's Guide
Table Of Contents
- Product Overview
- Basic Installation & Setup
- Mounting Installation
- Controller Management
- Access your wireless controller management page
- Change your controller administrative login password
- Change your controller LAN IP address
- Upgrade your controller firmware
- View your controller system log
- Backup and restore your controller configuration settings
- Reboot your controller
- Set idle timeout for users logged into controller management
- Reset your controller to factory defaults
- Controller default settings
- Create additional users to access controller management
- Set your controller date and time settings
- Power over Ethernet (PoE) Settings
- Power over Ethernet (PoE) Scheduling
- Access point management and configuration
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-WLC100P
41
When double clicking the AP icon, additional options will appear.
– Clicking this option will display a summarized list of information
about the AP.
o Locate – If the AP has been marked on a previously uploaded WAP
Map floorplan, clicking this link will reopen the floorplan.
o Reboot – Clicking this link will reboot the AP.
– Clicking this option displays a brief snapshot of the total amount of
data downloaded (received) by the AP over the last 5 minutes in graph form.
o Locate – If the AP has been marked on a previously uploaded WAP
Map floorplan, clicking this link will reopen the floorplan.
o Reboot – Clicking this link will reboot the AP.
- Click this option will remove the AP from the location on the floorplan
and the AP will be moved back to the list of available APs on the left side.
Deleting and resetting floor plans
To delete a map, click on the Select Map drop-down list and select the map to delete.
Click Delete to delete the floor plan.
Clicking Reset will reset the floor plan and remove all the access points that were added
to the floor plan.