Technical data

All files are to be located in the $SystemRoot$\System32 directory. After calling
the Control Panel, the "UPS NT Control" icon appears (see fig. 9-9 "UPS pro‐
gram icon in the Windows XP Control Panel" on page 72).
The settings for the service can be set here.
The service can be stopped or exited only by using the Service Manager in the
Computer Management (Services). The Service Manager can be accessed for
example under Control Panel ▶ Administrative Tools ▶ Services.
Fig.9-11: "Service Manager" in the Computer Management
Then the marked entry "UPS NT Service" can, depending on the state, be star‐
ted, stopped or exited via the context menu entries "Start", "Stop" or "Exit".
Administrator rights are required!
9.4 Maintenance Software
9.4.1 General Information
For all VSB 40.3 devices, the maintenance software "IPCMnt.exe" is installed
by default. With this software different information about the device can be ob‐
tained or settings and tests can be carried out.
Call the software via Start ▶ ProgramFiles ▶ Bosch Rexroth ▶ IPCMnt.exe.
The maintenance software contains the following tabs:
● "Touch", touch screen calibration, see chapter 9.4.2 "Touch" on page
76.
● "el. Type Plate" electronic type plate, see chapter 9.4.3 "El. Type Plate"
on page 77.
● "SMART" information about the hard disk, see chapter 9.4.4 "SMART" on
page 77.
● "HW Monitor" HW information, see chapter 9.4.5 "HW Monitor" on page
78.
● "About" device informationen, see chapter 9.4.6 "About" on page 79.
Project Planning Manual | Rexroth IndraControl VSB 40.3 Electric Drives
and Controls
| Bosch Rexroth AG 75/101
Software