Technical data

DANGER
Uncontrolled machine movements or data loss when the batteries are
defective!
If no batteries are available or if the batteries are defective or discharged, the
system RESET is executed after a voltage breakdown, without prior notice!
This could cause uncontrolled machine movements or data loss.
9.3.2 Configuration
Calling the configuration software is carried out in the Windows XP Control
Panel by selecting the "UPS NT Control " icon .
① UPS NT control software icon
Fig.9-9: UPS program icon in the Windows XP Control Panel
The dialog shown in fig. 9-10 "Configuration dialog of the UPS NT software" on
page 73 is used for specifying the starting behavior and the runtime behavior
of the UPS NT software. The individual values of the configuration are saved
in the registry.
A stop and a subsequent restart of the service with modified parameters is
performed after pressing "OK".
The UPS NT Control always runs as a Windows service. Changing
the user does not influence this behavior. The user cannot end the
program without administrator rights or cannot stop the monitoring.
The following dialog appears after starting the program:
72/101 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraControl VSB 40.3 | Project Planning Manual
Software