User manual
Table Of Contents
- Table of Contents
- Safety Warning
- Chapter 1. Introduction
- 1.1 Overview
- 1.2 Hardware Illustration
- 1.2.1 VS-8040U-RP/VS-8032U-RP/VS-8024U-RP
- 1.2.2 VS-8040/VS-8032/VS-8024
- 1.2.3 VS-6020 Pro/VS-6016 Pro/VS-6012 Pro
- 1.2.4 VS-5020/VS-5012
- 1.2.5 VS-4016U-RP Pro/VS-4012U-RP Pro/VS-4008U-RP Pro
- 1.2.6 VS-4016 Pro/VS-4012 Pro/VS-4008 Pro
- 1.2.7 VS-4016U-RP
- 1.2.8 VS-2012 Pro/VS-2008 Pro
- 1.2.9 VS-2012/VS-2008
- 1.2.10 VS-201P/V
- 1.2.11 NVR-104P/V
- 1.2.12 VS-101P/V
- Chapter 2. Install VioStor
- Chapter 3. Use VioStor by Local Display
- Chapter 4. Use VioStor by Web-based Interface
- Chapter 5. Playback the Video Files
- Chapter 6. System Administration
- Chapter 7. System Maintenance
- Chapter 8. LCD Panel
- Chapter 9. Troubleshooting
- Appendix A Dynamic Domain Name Registration
- Appendix B Configuration Examples
- Technical Support
- GNU GENERAL PUBLIC LICENSE
31
3. Finder detects the VioStor servers on the local network. If the server has not
been initialised, you will be prompted to perform quick setup. Click “Yes” to
continue.
Note: If VioStor is not found, click “Refresh” to try again.
4. You must enter the administrator name and password to perform quick setup.
The default administrator name and password are as below:
Use name: admin*
Password: admin
*If you are using the VS-201/VS-101/NVR-104, the default login name is
“administrator” and the login password is “admin”.
Note: Make sure all the IP cameras are configured and connected to the
network.