Technical data
1. Welcome to the Create Backup Wizard!
Wizard start window.
2. Select Backup Type
Selection of the backup type. There are two checkboxes for selecting if a
full backup (individual partition, all partitions) or a partial backup (individual
directories and files) is to be performed. A note that informs about what
can be stored in the marked backup type appears in the "Description"
zone.
3. Partitions Selection
Select partition(s) to be backed up. All partitions of the hard disk for se‐
lection are displayed.
Note: In this selection also the selection of the Acronis Secure Zone is
displayed. If this the Acronis Secure Zone or the full hard disk including
the Acronis Secure Zone is selected for backup, a note appears, that an
image of this zone is not recommended, as it contains itself only backed
up images.
4. Source File Exclusion
Exclusion of certain file types or directories. Certain file types or directories
can be excluded from storing in the image. After the selection of a file type
in the window further file types can be added or removed.
5. Backup Archive Location
Select the image archive file to be updated or extended.
6. Select Backup Mode
Select "Create an incremental backup".
7. If the archive defined in ⓢ is protected with a password, the Archive Pro‐
tection dialog appears for entering the password.
8. Choose Backup Options
Via "Set the options manually" different settings for the backup process
can be defined. The possible options are described in ⑦ in chapter
9.2.4 "Creating Image Archives " on page 60.
9. Archive Comments
Here, you can enter a meaningful comment about the image archive file.
This simplifies the identification of the image archive at a later time.
10. Proceed
Finishing the wizard and starting the image creation.
9.2.7 Restoring Image Archives
It might be possible to restore images because of various reasons. The most
frequent causes are hard disk defects, a virus, the recovery after a program test
or a defect of the operating system, e. g. by working with the registration editor.
The recovery of one or several partitions from an image archive is started in the
main program window via the "Recover" function.
We recommended you to restore image archives only with the
Startup Recovery Manager or the rescue media.
Windows system partitions can only be restored by the Startup Re‐
covery Manager or by the rescue media.
64/101 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth IndraControl VSB 40.3 | Project Planning Manual
Software