Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- 1. Introduction
- 2. Plug-in Installation
- 3. Activate your TC8210 iLok license
- 4. Connection and Setup
- 4.1 Connecting the TC8210-DT Desktop Controller (when you have purchased the DT Desktop Controller version)
- 4.2 Operating the TC8210
- 4.3 Insert vs Aux Effect
- 4.4 Mono/Stereo Operation
- 4.5 Travel Period and Module Connection (when you have purchased the DT version):
- 4.6 Primary and Secondary Controls
- 4.7 Connection Status to the Hardware Unit
- 5. Plug-in and Hardware Controls
- 6. Presets
- 7. Software Updates
- 8. Specifications
14 TC8210 User Manual
User Presets
As soon as you make an alteration to any of the parameters in that preset, the
text changes to italics to indicate that something has changed. This is also
indicated by a red dot after the red preset number on the hardware unit and in
the plug-in user interface.
You can click in the PRESET window, then select the Save As option. (If you
navigate away from that preset, then the changes will be discarded.)
The altered preset will be saved as a user preset, with your new name for it, and
will appear in the User Presets list.
If you modify a user preset, you have the option to "Save" (rewriting over the
existing user preset) or "Save As" (save as a new user preset).
If you modify a factory preset, then only "Save As" is available (to save as a new
user preset). Factory presets cannot be overwritten.
User Presets are not given a number unless you press the ASSIGN button and
select a number. (See Favorite Presets below.)
Presets can also be recalled from the hardware unit in the MAIN section: Press the
SELECT button to highlight "PRESET" with a red dot, and then press the VALUE UP
or DOWN arrows to scroll through the presets one slot at a time.
Favorite Presets
Creating your own presets will make them accessible from the User Preset menu,
but they will only be numbered if you set them as a favorite. This is done by
assigning a favorite slot number to the preset using the Favorite menu as follows:
Click the ASSIGN button in the right side of the user interface.
The Assign Favorite menu will appear.
Select one of the banks of 10, and then select the desired preset slot number.
Your currently loaded preset will then be saved with that favourite number.
(If the current preset already has a favorite number, then that number is
greyed-out on the Assign Favorites menu, but you can still save it as a dierent
favorite number.)