Manual

Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know
how to operate your model properly. After you have finished
reading the instructions, put them away in a safe place for future
reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the
explanatory drawings. However the method of connecting and
operating the unit is the same.
IMPORTANT NOTICE
The serial number for this equipment is located on the rear panel.
Please write this seriai number on your enclosed warranty card
end keep it in • secure area. This is for your security.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
THE POWER SWITCH IS SECONDARY CONNECTED AND /
THEREFORE DOES NOT SEPARATE THE UNIT FROM MAINS
1POWER IN THE STANDBY POSITION.
IMPORTANT
Tbe lightning flash wit h arrowbead symbol,within
an equilateral triangle, is intended to alert the
user to the presence of uninsubeed "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
CAUTION
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR RACK). NO USER SER-
VICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral
triangle isintended to alert the user tot he presence
of important operating and maintenance
(servicing) inctructions in the literature
accompanying the appliance,
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipmer_t does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
CHANNEL STEP SETTING (except for U.S. model)
The unit has been factory preset to the channel allocation value for the area in which it is to be sold. If this value is set
incorrectly, the tunes in frequency may be wrong, or sound may be distorted, resulting in an inability to reproduce
reception signals at their proper sound quality. For this reason, be sure to confirm that the values are set correctly before
first using the unit.
FM 100 kHz, AM 10 kHz:
Set to this position for areas with an FM reception stepof 100 kHz and AM 10kHz.
FM 50 kHz, AM 9 kHz:
Set to this position,for areaswith an FM receptionstep of 50 kHzand AM 9 kHz.
NOTE:
When unsure about the channel allocation for your area, consult your dealer for correct information.
To Change Channel Steps
With the power turned OFF, hotd the STANDBY/ON button depressed white pressing the FM/AM function button to turn
the power ON.
• Each time the above operation is performed, the channel tuning step will a(ternate between FM 100 kHz/AM 10 kHz,
and FM 50 kHz/AM 9 kHz.
STANDBY/ON FM/AM
2
<ARB7157>