Manual

[Video Components Connections

• When connecting components, the receiver should be off and the power cord unpluged.

• Connect your video components as shown below. Also, refer to "Digital Connections" on page 11 when making

digital connections from your DVD or LD player.

• Although only "$2" is printed on the S-Video jacks on the rear panel, S, $1 and $2 S-video connection can be made

as well NSX-D608 U.S. model only).

• If your "IV monitor or video camera has an S-Video input, clearer picture reproduction is possible by connecting the

receiver to your TV monitor or video camera via the S-Video jack (VSX-D608 only). IVSX-D608 only)

iv,o,bbvi.,o,

it .t it

I I ii1_

, @ R® ®L ®

CA;'© , o.I ®®®®"

@@@@-

- Z-7 _ _- _ F

VSX-D608 only

VSX-D6O8 only:

When connecting components equipped with

S-video jacks, you can make connections to

this unit using S-video cords (not supplied).

However, this unit is not designed to convert

the format of the video signal. Therefore, the

signal from the $2 IN cannot be output from

the VIDEO OUT and similarly the signal from

the VIDEO IN cannot be output from the $2

OUT.

t !

VSX-D,

I II °v°.-I

(or satellite tuner) (or LD player)

• Audio/Video cords

Use audio/video cords (not supplied) to connect the

video components and a video cord to connect the TV

or monitor.

Connect red plugs to R (right),

white plugs to L (left), and the

yellow plugs to VIDEO.

Be sure to insert completely.