Use and Care Manual

for those who appreciate quality, reliability & performance

Optional Accessories

CLEANINGTHECARPETSHAMPOOSYSTEM

(cont)

To remove the Shampoo Tank from the Air Exhaust

Port

19 , rotate it away from the Ultimate G as far as it

will go, then lift it upwards. ➤

Remove and clean the Suds Screen Cap, Cup and

Sponge Filter.

Rinse out the Shampoo Tank with cold water and

replace the Screen Cap, Cup and Sponge Filter.

NOTE: The belt should not be stretched for extended periods.

Make sure the green arrows on the nozzle line up for storage.

(Remember to align the red arrows before replacing the nozzle

on the Ultimate G

-seeBeltLiftersectiononpage10.)❏

REPLACINGAWORNCARPETSHAMPOO

SYSTEMNOZZLEBELT

ToreplacetheCarpetShampooSystemNozzleBelt,

push the thumb pads located at each end of the shield

and rotate the shield up and away from the brush. ➤

Push down carefully on the ends of the brush with

your thumbs. The brush will snap out and the belt

can be replaced.

Becertainthebeltisplacedinthecenterofthebrush.

NOTE: Use only approved Kirby

belts. ➤

The Carpet Shampoo System (continued)