Use and Care Manual

The Kirby Company

Taking care to avoid spilling liquid on the Ultimate G

or the floor, place the opening in the bottom front of

the Shampoo Tank over the Air Exhaust Port

19 on the

Ultimate G. Angle the Shampoo Tank outward from the

Ultimate G until the arrows line up. Next, slide the Shampoo

Tank down over the locking pins on the Air Exhaust Port.

Rotate the Shampoo Tank toward the Ultimate G (clockwise)

to lock it in place. ➤

Push the round elbow into the hole in the tray until it

snaps into place. Firmly insert the other end over the

fitting at the bottom front of the Shampoo Tank. ❏

USINGTHECARPETSHAMPOOSYSTEM

To set the nozzle to the proper height, step on the Toe-

Touch Control

™

Upper Pedal

8 as often as necessary

to lower the nozzle to its lowest position. ➤

NOTE: Forcing the brushroll into the surface of the carpet

decreases its ability to thoroughly clean the carpet and could

damage the belt and brushroll.

Turn the Suds Control Valve all the way to the right

(clockwise) to the ON position. Turn the Ultimate G

ON and engage TechDrive

Power Assist (see page 8

for details). Suds flow will begin immediately.

Control the amount of suds by turning the Suds Control

Valve left (counter-clockwise) for decreased suds flow and

right (clockwise) for increased suds flow. Turning the valve

all the way to the left (counter-clockwise) to the OFF posi-

tion will stop the flow of suds completely.

Stopping the flow of suds allows you to thoroughly brush all

the suds into the carpet before applying more suds. This also

lets you spot scrub badly soiled areas. ➤

Optional Accessories

The Carpet Shampoo System (continued)