Service Manual

Groundsmaster 7200/7210Page 1 – 4Safety
Jacking Instructions
CAUTION
When changing attachments, tires or performing
other service, use correct blocks, hoists and
jacks. Make sure machine is parked on a solid lev-
el floor such as a concrete floor. Prior to raising
machine, remove any attachments that may inter-
fere with the safe and proper raising of the ma-
chine. Always chock or block wheels. Use ap-
propriate jack stands to support the raised ma-
chine. If the machine is not properly supported by
appropriate jack stands, the machine may move
or fall, which may result in personal injury.
Jacking the Front
1. Apply parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack to machine:
A. On machines with cutting deck, position jack se-
curely under the square carrier frame tube near the
front castor wheel (Fig. 1). Do not use the cutting
deck as a jacking point.
B. On machines with Polar Trac
TM
Kit, position jack
securely under the lift arm pivot tube on the front of
machine. Do not use the implement as a jacking
point.
3. Use jack to raise front of machine.
4. After raising the front of the machine, use appropri-
ate jack stands under the frame to support the front of
the machine.
Jacking the Rear (Fig. 2)
IMPORTANT: Do not support machine on wheel
hubs (brake rotors).
1. Chock both front castor wheels to prevent the ma-
chine from moving.
2. Place jack securely under the rear frame.
3. Jack rear wheels off the ground.
4. Use appropriate jack stands under the frame to sup-
port the rear of the machine.
1. Front castor wheel 2. Front jacking point
Figure 1
2
1
Figure 2
FRONT OF MACHINE