Integrator's Manual

91
In order to customize the EPG to match the property‟s lineup, you will need to go back to the
main EPG screen by clicking the EPG link at the top of the page. From this screen, you will
need to tell the COM24 card where to send the EPG data (an edge QAM, for instance), define a
time zone offset, and modify the lineup as needed. You may also upload a logo for the property
that will be displayed in the upper right corner of the EPG. See Section 6.10.3 for instructions
on selecting and uploading a logo.
When modifying the EPG channel lineup, the channels can be entered in any order, as the
COM24 card will automatically sort them by channel number when it builds the guide. As with
the tuning table on the TuneAll page, you may edit the EPG information in its text field on the
page, but it is recommended that you make all changes in a separate text editor and save a copy
of the text file for easy retrieval in the case of any information loss.
Once you are finished entering all of the information necessary to build your EPG, simply click
the “Submit Query” button at the bottom of the screen. Doing so will provide you with a screen
that reports all of the data the COM24 card has been sent. This screen will look similar to the
resulting screen after clicking the EPGLoad button. Once the EPG has had enough time to
configure, the resulting guide channel should look like Figure 48 below.
Figure 48 – Guide Channel (EPG)