Integrator's Manual

6.8.4 Using the COM24 LED Control Feature

The information shown in Figure 38 below is one of the subsections available on the Advanced

Edit page.

Figure 38 – “LED Control” Interface on Advanced Edit page

This section gives you the ability to assume control of the PWR LED temporarily. This feature

can help you easily identify a specific card within a chassis if there is ever any doubt about

which card you are accessing. A brief explanation of each field shown above is as follows:

LED_State – This field allows you to control the PWR LED. This may be used as a simple

means to identify a particular card within a chassis at a remote location. The allowed values are:

0 = Off

1 = On

2 = Flashing