Quick Guide

15
EN
CARE & CLEANING
WARNING
Do not immerse the power
cord, power plug or appliance
in water or any other liquid.
The water tank should never
be removed or completely
emptied during descaling.
TO DESCALE
1. Empty the drip tray and re-insert into
position on the machine.
2. Fill the water tank to the DESCALE line
indicated and add the descaling agent
to the water.
2L
68oz
DESCALE
1000
+
0.5s
5s
OR
&
2
L
68oz
MAX
3. Place a 2L / 68 .oz container under the
grouphead and steam wand.
4. Turn the machine o by simultaneously
pressing the 1 CUP and STEAM
buttons, and allow it to completely cool
before descaling.
2L
68oz
DESCALE
1000
+
0.5s
5s
OR
&
2L
68oz
MAX
5. With the machine o, press the 1 CUP
and STEAM buttons simultaneously for
5 seconds to enter descale mode.
2L
68oz
DESCALE
1000
+
0.5s
5s
OR
&
2
L
68oz
MAX
6. The 1 CUP and STEAM buttons will
illuminate, indicating that the machine
is ready to start descaling.
2L
68oz
DESCALE
1000
+
0.5s
5s
OR
&
2
L
68oz
MAX
7. Press the 1 CUP or STEAM
button to begin the descale cycle.
These buttons will alternately ash
throughout the cycle.
8. Once the descale solution has been
used up, the descale mode will pause.
Rell the water tank to the MAX line and
empty the waste water container, then
replace both parts on to the machine.
9. The 1 CUP and STEAM buttons will
illuminate when the machine is ready.
Press the 1 CUP or STEAM button to
resume descaling.
10. When descaling is complete, the 1CUP
and STEAM button will alternately
ash. The machine will then go into
standby mode.
2L
68oz
DESCALE
1000
+
0.5s
5s
OR
&
2
L
68oz
MAX
11. Remove and empty the waste water
container. Rinse the drip tray and water
tank and dry thoroughly before replacing
them back onto the machine.
STEAM WAND BLOCKED
During milk texturing, if the machine detects that
the steam wand is blocked, it will immediately stop
operating and the STEAM button light will be o.
Both the milk temperature and milk foam lights will
fully illuminate and ash. These lights will ash until
a manual steam purge has been completed.
CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand with
a damp cloth.