User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Preparations & Installation
- Chapter 3 Network Service Configurations
- Chapter 4 VoIP Telephone Adapter Configurations
- Chapter 5 Netowrk
- Chapter 6 NAT Trans
- Chapter 7 SIP Setting
- Chapter 8 Advance Setting
- Chapter 9 Other Setting
- Appendix A Voice Communication Samples
- Case 1: ATA to ATA connection via IP address
- Case 2: (Peer-to-Peer mode) VIP-157S Port 1 to Port 2 communications
- Case 3: Call Forward Feature_Example 1
- Case 4: Call Forward Feature_Example 2
- Case 5: Call Forward Feature_Example 3
- Case 6: Call Forward Feature_Example 4
- Case 7: Auto Answer Feature_IP to PSTN
- Case 8: Auto Answer Feature_PSTN to IP
- Appendix B The method of operation guide
- Appendix C VIP-156/VIP-156PE/VIP-157/VIP-157S Specifications
44
9BChapter 8
Advance Setting
8
42BStatus Log
Display and saving systems running status message data, Press “Get Status Log” can backup the
status log file.
43BAuto Config
T This page defines the Auto Configuration (Auto Provision) setting. ATA supports TFTP, FTP, HTTP
and IP PBX auto configuration function in total. In IP PBX Auto Configuration Setting you need to check
with your service provider if they have provided this function.