Owners manual

Hardware options installation 131
5.
Remove the serial cable blank.
6. Connect the serial cable option. Then, remove the backing from the double-sided tape and press
down where indicated.
7. Install the access panel (on page 28).
8. Slide the server into the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server ("Powering up the server" on page 26).
M.2 SSD Enablement Board option
The M.2 enablement board is supported in all 6 of the PCI slots on this server.
Installing an SSD module on the M.2 SSD Enablement Board
1. Power down the server (on page 26).