Users Guide

Table Of Contents
Die iDRAC-Webschnittstelle wurde für den Einsatz mit den entsprechenden Tastaturen für die unterstützten Sprachvarianten entwickelt.
Einige Funktionen der iDRAC-Webschnittstelle, wie z. B. virtuelle Konsole können zusätzliche Schritte für den Zugriff auf bestimmte
Funktionen/Buchstaben erfordern. Andere Tastaturen werden nicht unterstützt und können ggf. unerwartete Probleme verursachen.
ANMERKUNG: Lesen Sie in der Dokumentation zum Browser nach, wie verschiedene Sprachen konfiguriert und eingerichtet
werden, und lassen Sie sich lokalisierte Versionen der iDRAC-Webschnittstelle anzeigen.
Updating device firmware
Using iDRAC, you can update the iDRAC, BIOS, and all device firmware that is supported by using Lifecycle Controller update such as:
Fibre Channel (FC) cards
Diagnostics
Operating System Driver Pack
Network Interface Card (NIC)
RAID Controller
Power Supply Unit (PSU)
NVMe PCIe devices
SAS/SATA hard drives
Backplane update for internal and external enclosures
OS Collector
CAUTION: The PSU firmware update may take several minutes depending on the system configuration and PSU model.
To avoid damaging the PSU, do not interrupt the update process or power on the system during PSU firmware update.
NOTE:
While performing a PSU firmware update through the host OS in the 15
th
Generation PowerEdge servers, ensure that you
perform a cold reboot to apply the update.
When updating the PSU firmware for PowerEdge C series servers, ensure that all servers in the same chassis are powered OFF first.
If any of the other servers in the chassis are powered ON, the update process fails.
Upload the required firmware to iDRAC. After the upload is complete, the current version of the firmware that is installed on the device
and the version being applied is displayed. If the firmware being uploaded is not valid, an error message is displayed. Updates that do
not require a reboot are applied immediately. Updates that require a system reboot are staged and committed to run on the next system
reboot. Only one system reboot is required to perform all updates.
NOTE:
When SEKM mode is enabled on a controller, iDRAC Firmware downgrade/upgrade shall fail when tried from a SEKM to a
non-SEKM iDRAC version. iDRAC Firmware upgrade/downgrade shall pass when done within the SEKM versions.
PERC firmware downgrade shall fail when SEKM is enabled.
After the firmware is updated, the System Inventory page displays the updated firmware version and logs are recorded.
The supported firmware image file types are:
.exe — Windows-based Dell Update Package (DUP). You must have Control and Configure Privilege to use this image file type.
.d9 — Contains both iDRAC and Lifecycle Controller firmware
For files with .exe extension, you must have the System Control privilege. The Remote Firmware Update (licensed feature) and Lifecycle
Controller must be enabled.
For files with .d9 extension, you must have the Configure privilege.
NOTE: Ensure that all nodes in the system are powered off before updating the PSU firmware.
NOTE: After upgrading the iDRAC firmware, you may notice a difference in the timestamp displayed in the Lifecycle Controller log.
Time that is displayed in LC Log is different from NTP/Bios-Time for few logs during idrac reset.
You can perform firmware updates by using the following methods:
Uploading a supported image type, one at a time, from a local system or network share.
Connecting to an FTP, TFTP, HTTP or HTTPS site or a network repository that contains Windows DUPs and a corresponding catalog
file.
78
Managed System einrichten