Owners Manual
Table Of Contents
- Latitude 12 Rugged Extreme Tablet – 7212 Owner's Manual
- Contents
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw size list
- Battery
- Installing the battery when the cross strap is attached - Optional
- Subscriber Identification Module (SIM) card
- Display assembly
- Stylus
- WLAN card
- WWAN card
- CMOS battery
- Power button assembly
- Micro serial port and power connector port
- Front camera
- Microphone
- Heat sink for SSD
- PCIe Solid State Drive (SSD)
- System fan
- System Board
- Docking Board
- Back Camera
- Smartcard holder
- Bottom base assembly
- Technology and components
- Software
- System specifications
- Product overview
- Power and battery-status light
- System specifications
- Processor specifications
- Memory specifications
- Storage specifications
- Audio specifications
- Video specifications
- Camera specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Touch specifications
- Adapter specifications
- Physical dimension specifications
- Environmental specifications
- System setup
- Boot Sequence
- Navigation keys
- System Setup overview
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot
- Intel software Guard Extensions
- Performance screen options
- Power Management
- POST Behavior
- Manageability
- Virtualization Support options
- Wireless options
- Maintenance
- System Log
- Support Assist System Resolution
- Troubleshooting
- Ecosystem Accessories
Smartcard holder
Removing smartcard holder
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Battery
b. Display assembly
c. System board
3. To remove the smartcard holder:
a. Place the back side of system on a flat surface.
b. Locate the smartcard holder.
c. Remove the screws (10) that secures the smartcard holder to the system board.
4. Remove the copper adhesive shield that secures the smartcard holder.
48
Removing and installing components