Owners Manual
Table Of Contents
- Latitude 12 Rugged Extreme Tablet – 7212 Owner's Manual
- Contents
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw size list
- Battery
- Installing the battery when the cross strap is attached - Optional
- Subscriber Identification Module (SIM) card
- Display assembly
- Stylus
- WLAN card
- WWAN card
- CMOS battery
- Power button assembly
- Micro serial port and power connector port
- Front camera
- Microphone
- Heat sink for SSD
- PCIe Solid State Drive (SSD)
- System fan
- System Board
- Docking Board
- Back Camera
- Smartcard holder
- Bottom base assembly
- Technology and components
- Software
- System specifications
- Product overview
- Power and battery-status light
- System specifications
- Processor specifications
- Memory specifications
- Storage specifications
- Audio specifications
- Video specifications
- Camera specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Touch specifications
- Adapter specifications
- Physical dimension specifications
- Environmental specifications
- System setup
- Boot Sequence
- Navigation keys
- System Setup overview
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot
- Intel software Guard Extensions
- Performance screen options
- Power Management
- POST Behavior
- Manageability
- Virtualization Support options
- Wireless options
- Maintenance
- System Log
- Support Assist System Resolution
- Troubleshooting
- Ecosystem Accessories
CAUTION: Speaker cable is accessible after you remove the pogo pin docking connector cable. Ensure to
remove pogo pin docking cable before removing speaker cable.
4. To remove the system board:
a. Remove the screw (1) that connects the antennas for radio pass-through connectors on the system board [1].
b. Flip the connector upward [2].
NOTE: Avoid peeling off the copper shield, and ensure not to flap the copper shield by more than 75°.
c. Disconnect the antennas for radio pass-through connectors cable on the system board with a plastic scribe [3].
d. Remove the screws (5) that secures the micro serial port, and USB Type-C port metal bracket [4].
e. Lift the metal bracket from the system chassis [5].
NOTE: Metal bracket are secured with 5 screws. Lift both the brackets.
42 Removing and installing components