Installation Instructions

19
Panels are heavy. Use
caution when handling to
avoid injury or damage. Use
adequate number of people to safely handle
panel.
Install Sliding Panels
On 4-Wide units, the two sliding panels are
shipped uninstalled. There is an active and inactive
sliding panel.
The active panel contains the latching mechanism
inserted in the door stile (FIGURE 1).
The inactive panel contains the latch keeper and
the shootbolts (FIGURE 2).
1. Securely support both sliding panels on a clean,
flat surface so you can access the rollers in the
bottom of each panel. There is a roller assembly in
each lower corner.
NOTE: Top screw in (FIGURE 3) is the roller
installation screw. Do NOT use the top
screw for adjusting rollers.
2. Insert a Phillips screwdriver into the roller adjust-
ment hole at the bottom of the panel and turn the
adjustment screw counterclockwise to completely
retract the rollers (FIGURE 3). Fully retract both
rollers on both panels.
FIGURE 3
Roller
Assemblies
Sliding Panel
Roller Installation
Screw
Roller
Adjustment Screw
Install Sliding Panels – 4-Wide Door
FIGURE 1
FIGURE 2
FIGURE 4
Roller
Assembly
Sliding Panel
Roller Installation
Screw
Roller
Adjustment Screw
Adjust Sliding Panel – 2-Wide Door (cont.)
Adjust Sliding Panel – Turn adjusting screw
(FIGURE 4):
Clockwise – Lower Rollers – Raise Panel
Counterclockwise – Raise Rollers – Lower Panel
NOTE: Before adjusting, use putty knife to lift panel
slightly, taking weight off rollers (FIGURE 1
Page 18).
Use roller adjustment screw (FIGURE 4) to raise or
lower panel to achieve smooth operation and to
keep panel level and plumb.