Installation Instructions

Screen Adjustment

To adjust screen for smooth operation use a

Phillips screwdriver on the adjustment screw in

each screen roller (FIGURE 1 & 1A). Turn clock-

wise to extend the roller or turn counterclockwise

to retract the roller. There are rollers at each

corner, both top and bottom. For best results all

rollers should be adjusted.

NOTE: To raise screen, top rollers need to be

retracted and bottom rollers extended.

To lower screen top rollers need to be

extended and bottom rollers retracted.

Install Screen Keeper

1. Measure 37-1/4" upward from flat top of screen

track and mark the side frame at this point. Mark

should be centered in the frame channel

(FIGURE 2).

2. Position screen keeper so bottom screw hole is

centered over the mark on the side frame.

3. Fasten bottom screw through keeper and into

mark on frame. Fasten top screw. Do not tighten

screws completely.

4. Close screen and activate screen lock to check

for correct alignment. Adjust keeper up or down, if

necessary, for proper locking, then tighten screws.

FIGURE 2

Screen

Track

37 1/4"

Lock

Keeper

Screen

Keeper

Screw

Screen Adjustment

Installing Screen Keeper – 2 Wide Door Only

FIGURE 1

Screen

Roller Adjustment

Screw