Installation Instructions

18
Panels are heavy. Use
caution when handling to
avoid injury or damage. Use
adequate number of people to safely handle
panel.
NOTE: The sliding panel is normally shipped
completely installed.
Remove Sliding Panel
1. Slide panel open about 12".
2. Insert a stiff-bladed putty knife into sill channel
and gently raise door to remove pressure from
roller assembly (FIGURE 1).
3. With a Phillips head screwdriver, turn roller
adjustment screw (FIGURE 1 & FIGURE 4 on
Page 19) counterclockwise to completely retract
rollers. Repeat for other bottom roller.
NOTE: Top screw seen in FIGURE 1 houses roller
installation screw. Do NOT use the top
screw for adjusting rollers.
4. Grasp both sides of panel and lift the panel up
into the head frame channel (FIGURE 2).
5. Pull bottom of panel toward you and remove
panel from frame.
Install Sliding Panel
1. With panel laying down, insert a Phillips screw-
driver into the roller adjustment screw at the
bottom of the panel and turn counterclockwise to
completely retract the rollers (FIGURES 1, 2 & 3).
Repeat for other roller set.
2. With panel upright and rollers down, position
panel near the center of the frame and lift it up
into the head frame channel (FIGURE 2).
3. Carefully push bottom of panel away from you
until it clears the inside of the sill and is positioned
properly in the frame channel. A stiff-bladed putty
knife can be used to help slide panel into channel.
NOTE: The rollers must be correctly seated on the
roller track so the panel operates smoothly.
Groove of rollers must rest on crown of
roller track (FIGURE 3).
Continued on next page.
FIGURE 2
FIGURE 3
Track
Roller
Sill
Panel
Sliding
Fixed
Panel
Hole Plugs
Head
Adjustment
Screw
Roller Installation
Screw
Remove & Install Sliding Panel
Adjust Sliding Panel – 2-Wide Door
FIGURE 1
Relieve pressure on roller
assembly by lifting panel
with a stiff-bladed putty knife (FIGURE 1)
while turning roller adjusting screws.
Failure to release panel weight while turn-
ing adjustment screws may damage panel
adjustment system.
SILL
TRACK
CAP
SILL
TRACK
ROLLER
INTERIOR
DOOR
FRAME
SLIDING
PANEL