User's Manual

Installing the 9A656-04 Module
2-6
The 9A656-04 module is shipped without ANIMs. To install the ANIMs proceed
as follows:
1. Remove the module if it is installed in the SmartSwitch 9500 chassis. To
remove a module, release (rotate outward) the top and bottom plastic locking
tabs, then slide the module out of the chassis.
2. Refer to Figure 2-4. Remove the two screws fastening the coverplate to the
front standoffs where the ANIM is to be installed. Save the screws.
3. Lift and remove the coverplate from the top of the front standoffs.
Figure 2-4. Removing the Coverplate
4. Refer to Figure 2-5. Hold the ANIM by the provided cutouts on the board of
the ANIM.
!
CAUTION
The ANIM and 9A656-04 module are sensitive to static discharges. Use a
grounding strap and observe all static precautions during this procedure. Failure
to do so could damage the ANIM and the 9A656-04 module.
NOTE
If you are installing ANIMs in more than one slot, remove the cover plates from all
the associated slot openings.
A Phillips Head screwdriver is needed to install the ANIMs.
Front
Standoffs
RESERVED FOR ANIM
Coverplate