User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Introduction
- Installation
- Waking up the transmitter and the receiver
- Basic operations and on-screen display (OSD)
- Troubleshooting
- Supported resolution
- Audio bit rate support
- Product specification

11 Installation
2. Connect the transmitter’s HDMI OUT to HDMI input of a second display via an HDMI cable for
the loop-through connection.
3. Connect the IR blaster cable to the IR sensor of your high-definition AV equipment. You will be
able to use the remote control of the source device at the receiver side to directly operate the
source device like switching channels. Plug one end of IR blaster cable into the IR OUT jack of
the transmitter. Stick the IR blasters near the IR sensors of your high-definition audio/video
devices.
4. Connect the supplied power adapter to the DC in jack of the transmitter and a wall socket. The
indicator on the power button lights up in blue when the transmitter is connected to the power
socket.
1
2
HDMI In
HDMI out
3
4
IR blaster cable
Power cord
IR