User's Manual

10 Installation
Installation
This section will guide you on how to prepare the unit before its initial use.
As your Wireless FHD Kit could work with different projectors, the steps required to complete the
installation may vary according to actual environment and your projector specifications. Follow the
procedures below and refer to the specified sections for details.
1. Connect the transmitter to the desired devices and power properly. See Setting up the transmit-
ter (Tx) on page 10 for details.
2. Attach the receiver to your projector and connect power. See Setting up the receiver (Rx) on
page 12 for details.
3. Make sure that all the connected devices have been powered on. Press the source button of the
projector or of its remote control to select the appropriate HDMI video output, and make sure
that the source has been transmitted. See Powering up all devices and making source selection
on page 16 for details.
4. In most cases, you should be able to control the source devices by pointing their remote control
to the receiver. If the source device does not respond, perform IR sync by following instructions
in Performing IR sync on page 17.
Setting up the transmitter (Tx)
Connect up to four high-definition audio/video sources to the transmitter.
1. Connect the transmitter’s HDMI 1/HDMI 2/HDMI 3/HDMI 4 jacks to the high-definition AV equip-
ment’s HDMI out jacks via HDMI cables. The transmitter is equipped with four HDMI jacks for
the high-definition equipment such as Blu-ray Players or video game consoles.
1
2
3
USB
HDMI