User's Manual

Chapter 14 Quality of Service (QoS)
AMG1202-T10A User’s Guide
163
14.2.1 The QoS Settings Summary Screen
Use this screen to display a summary of rules and actions configured for the ZyXEL Device. In the
Advanced > QoS screen, click the QoS Settings Summary button to open the following screen.
Figure 86 Advanced Setup > QoS > QoS Settings Summary
The following table describes the labels in this screen.
Queue # Specify a Low, Medium, High or Highest queue tag to matched traffic. Traffic
assigned to a higher queue gets through faster while traffic in lower queues is
dropped when there is network congestion.
ADD Click this to add the rule.
DELETE Click this to remove the rule.
CANCEL Click this to restore previously saved settings.
Table 58 Advanced Setup > QoS
LABEL DESCRIPTION
Table 59 Advanced Setup > QoS > QoS Settings Summary
LABEL DESCRIPTION
Rules
# This is the rule’s index number.
Active This shows whether the rule is enabled or disabled.
Physical Ports This is the physical port associated with the rule.
Destination MAC
and IP/Mask Port
Ranges
This is the port range for destination MAC address and IP address.
Source MAC and
IP/Mask Port
Ranges
This is the port range for source MAC address and IP address.
Protocol ID This is the protocol ID associated with the rule.
VLAN ID This is the VLAN ID associated with the rule.
IPP/TOS (DSCP) This shows the IPP/TOS or DSCP settings.
802.1p This is the 802.1p priority level.
Actions
IPP/TOS (DSCP)
Remarking
The ZyXEL Device re-assigns the priority values specified in this field to
matched traffic.