User's Manual

Chapter 12 Static Route
AMG1202-T10A User’s Guide
150
12.1.1 What You Can Do in the Static Route Screens
Use the Static Route screens (Section 12.2 on page 150) to view and configure IP static routes on
the ZyXEL Device.
12.2 The Static Route Screen
Use this screen to view the static route rules. Click Advanced > Static Route to open the Static
Route screen.
Figure 78 Advanced > Static Route
The following table describes the labels in this screen.
Table 53 Advanced > Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Netmask This parameter specifies the IP network subnet mask of the final destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
Modify Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Remove icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.