User's Manual

Chapter 11 Filters
AMG1202-T10A User’s Guide
147
IP/MAC Filter Rule Editing
IP/MAC Filter Rule Index Select the index number of the filter rule.
Rule Type Select IP to allow or block traffic by IP addresses.
Active Use this field to enable or disable the rule.
Source Start IP Address Enter the source start IP address of the IP address range for the
packets you wish to filter. This field is ignored if it is 0.0.0.0.
Source End IP Address Enter the source end IP address of the IP address range for the packets
you wish to filter.
Port Number Enter the source port of the packets that you wish to filter. The range of
this field is 0 to 65535. This field is ignored if it is 0.
Destination Start IP
Address
Enter the destination start IP address of the IP address range for the
packets you wish to filter. This field is ignored if it is 0.0.0.0.
Destination End IP
Address
Enter the destination end IP address of the IP address range for the
packets you wish to filter.
Port Number Enter the destination port of the packets that you wish to filter. The
range of this field is 0 to 65535. This field is ignored if it is 0.
Protocol Select ICMP, TCP or UDP for the upper layer protocol.
Rule Unmatched Select the action for a packet not matching the rule.
Select Forward to forward traffic immediately and skip checking the
remaining rules. Select Next to check the next rule.
IP Filter Listing
IP Filter Set Index Select the index number of the filter set from the drop-down list box.
Interface This is the interface that the filter set applies to.
Direction The filter set applies to this traffic direction.
# This is the index number of the rule in a filter set.
Active This field shows whether the rule is activated.
Src Start IP/Src End IP This is the source IP address range.
Dest Start IP/Dest End IP This is the destination IP address range.
Src Port This is the source port number.
Dest Port This is the destination port number.
Protocol This is the upper layer protocol.
Unmatched When a packet doesn’t match the rule, this is the action the ZyXEL
Device takes on the packet.
Save Click this to save your changes.
Delete Click this to remove the filter rule.
Cancel Click this to restore your previously saved settings.
Table 52 Access Management > Filter (IP/MAC) (continued)
LABEL DESCRIPTION