User`s guide

P-793H v2 Support Notes

(3) On the SUMMARY menu, select a policy to edit by clicking Edit. On P-

793H v2, we can build at most 2 VPN Tunnels. Just make a click on the „Edit‟

button in the table, we can begin to configure the VPN rule.

(4) In the IPSEC Setup field, toggle Active check box and give a name, Test in

the example to this policy.

Select IPSec Key Mode to IKE, Negotiation Mode to Main, and

Encapsulation Mode to Tunnel, just the same as we will configure in Prestige

(5) Fill in the Local and Remote secure hosts information in the Local and

Remote field.

Local Address Type is Single and IP Address Start is PC 1‟s IP,

192.168.1.33 in the example.

Remote Address Type is Single and IP Address Start is PC 2‟s IP,

192.168.2.33 in the example.

(6) Fill in the VPN Gateway information in the Address Information field.