User's Manual

Chapter 26 Remote Node Setup
P-793H User’s Guide
268
Figure 155 Menu 11.1: Remote Node Profile (node 8)
The following table describes the labels in this menu.
Menu 11.1 - Remote Node Profile (Backup ISP)
Rem Node Name= ? Edit PPP Options= No
Active= Yes Rem IP Addr= ?
Edit IP= No
Outgoing: Edit Script Options= No
My Login=
My Password= ******** Telco Option:
Authen= CHAP/PAP Allocated Budget(min)= 0
Pri Phone #= ? Period(hr)= 0
Sec Phone #= Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Table 103 Menu 11.1: Remote Node Profile (node 8)
FIELD DESCRIPTION
Rem Node Name Enter the name of the ISP.
Active Select whether or not you want to use this Internet connection.
Outgoing This section is only enabled for PPPoA or PPPoE connections.
My Login Enter the user name provided by your ISP.
My Password Enter the password provided by your ISP.
Retype to Confirm Enter the password again.
Authen This field appears if you select PPPoE in the Encapsulation field. Select what
type of authentication your ISP uses. Select CHAP/PAP if you want the ZyXEL
Device to support both choices.
Pri Phone #
Sec Phone #
Type the phone number(s) for this remote node. If the Primary Phone number
is busy or does not answer, your ZyXEL Device dials the Secondary Phone
number, if available. Some areas require dialing the pound sign # before the
phone number for local calls. Include a # symbol at the beginning of the phone
numbers as required.
Edit PPP Options Press [SPACE BAR] to select Yes and press [ENTER] to configure the PPP
settings for the backup ISP. Menu 11.2 appears.
Rem IP Addr This field displays the type of routing the ZyXEL Device uses.
Edit IP/Bridge This field is enabled if Route is IP. If you want to set up the WAN IP address
and advanced features for the WAN port, press [SPACE BAR] to select Yes
and press [ENTER]. Menu 11.3 appears.
Edit ATM Options This field is enabled if Route is IP. Press [SPACE BAR] to select Yes and
press [ENTER] to edit the virtual channel and ATM QoS settings. Menu 11.1.6
appears.
Edit Advance Options This field is displayed if you are editing remote node 1, and it is only enabled
for PPPoE connections. If you want to set up advanced features for the
Internet connection, press [SPACE BAR] to select Yes and press [ENTER].
Menu 11.1.8 appears.
Telco Option This section is only enabled for PPPoA or PPPoE connections.