User's Manual

P-793H User’s Guide
263
CHAPTER 25
Internet Access Setup
Use this menu to configure your Internet connection. Use information from your ISP along
with the instructions in this chapter to set up your ZyXEL Device to access the Internet.
Contact your ISP to determine what encapsulation type you should use.
25.1 Internet Access Setup
Enter 4 in the main menu.
Figure 152 Menu 4: Internet Access Setup
The following table describes the fields in this menu.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= 0.0.0.0
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
Table 101 Menu 4: Internet Access Setup
FIELD DESCRIPTION
ISP’s Name Enter a descriptive name for your ISP for identification purposes.
Encapsulation Press [SPACE BAR] and then press [ENTER] to select the type of encapsulation
your ISP uses.
Multiplexing Press [SPACE BAR] to select the method of multiplexing used by your ISP. Choices
are VC-based or LLC-based.
VPI VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.