User manual

Indicator lights
These lights indicate the following functions:
• Drying (Drying) light: This light indicates that the ap-
pliance is in the drying phase.
• Anti-crease/End (Anti-crease/End) light: This light is
on at the end of the cooling phase, during the anti-
creasing phase and at the end of the programme.
• Tank (Tank) light: This light indicates that the appli-
ance is in the drying phase. This light comes on at
the end of the programme to remind you that the wa-
ter reservoir must be emptied out. If this light illumi-
nates during a programme this means that the water
reservoir is full. The buzzer sounds, the programme
stops, the light of the Start/Pause (Start/Pause) but-
ton flashes. This light comes on also when the water
reservoir is not inserted correctly.
• Filter (Filter) light: This light illuminates at the end
of the programme to remind you that the filters must
be cleaned.
• Condenser (Condenser) light: It comes on every 80
cycles to remind you that the condenser must be
cleaned.
Changing programme
To change a programme which has been selected by mis-
take once the programme has started, first turn the pro-
gramme selector to
OFF position. The programme
is cancelled.
The programme can no longer be changed direct-
ly once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob or if an function button (excluding the
Buzzer (Buzzer) button
2)
) is pressed, led on the Start/
Pause (Start/Pause ) button starts flashing temporarily
in red. The drying programme is not however affected
by this (laundry protection).
At the end of the programme
If the laundry is not removed at the end of the cycle, the
dryer performs an anticreasing phase (duration: 30 mi-
nutes maximum).
If you do not remove the laundry, the dryer will stop au-
tomatically at the end of the anticreasing phase. Lights
Anti-crease/End (Anti-crease/End ), and Tank (Tank)
remain lit and the buzzer sounds for 2 minutes.
Turn the programme selector dial to
to switch the
machine off. Remove the laundry from the drum and care-
fully check that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
If you open and then close the door before turning
the selector dial to
all the lights correspond-
ing to the phases making up the performed programme
come on.
After each use
• Clean the filters.
• Empty the water reservoir.
Cleaning and maintenance
Cleaning fluff filters
The filters collect all the fluff which accumulates during
drying. To ensure that the dryer works perfectly, the fluff
filters (fine filters and fluff filters) must be cleaned after
each drying cycle.
Caution! Never operate the dryer without fluff
filters or with damaged or blocked fluff filters.
2) Only dryers with buzzer button
24