User Manual
Table Of Contents
- ■ Using the PDF manual
- ■ System Requirements
- ■ Setup
- ■ Operating R Remote
- ■ Uninstalling the software(Removing the application)
- ■ Troubleshooting
R Remote Version 3 User’s Guide 28
“Device Information” dialog box
This appears when you choose [File] menu -> [Device Information].
This lists information about the R series devices that are connected.
① Device list
By right-clicking the name of an item such as Unit ID, you can select the items that are shown.
・ Unit ID
Shows the UNIT ID of the device.
・ Product
Shows the model name of the device.
・ Name
Shows the device name. This name can be edited in Dante Controller.
・ Mode
Shows the START UP MODE of the device.
・ IP Address
Shows the IP address that is specified for the device.
・ Port No.
Shows the communication port number of the device.
・ Firmware
Shows the main firmware version of the device.
② [Set IP Address] button
When you click this button, the “IP Address” dialog box
will appear (excluding RMio64-D).
③ [Properties] button
When you click this button, the “Properties” dialog box
will appear.
④ [OK] button
Closes the dialog box.